For solid/perforated blocks + porous concrete blocks. Enables the efficient screw fixing of the UdiRECO® boards on all monolithic substrates and their fine adjustment on uneven surfaces. Thermally decoupled.
Suitable for UdiASSEMBLY SDH RECO
Enables the efficient fixing of the UdiRECO Boards on all timber substrates and their fine adjustment on uneven surfaces. Enables millimetre-exact fine adjustments.
Suitable for UdiASSEMBLY SDM RECO
The insulation screw cap permits a simple fixing on uneven surfaces.
Special screw combination for thermal bridge-free fixing of the UdiCLIMATE insulation boards to timber and metal substrates.
Rust-free. Suitable for compressed air staple gun.
Fixing combination with plug for mineral-based foundations/substrates. H-Profile as butt joint connector for the UdiBASE® Plinth-End Cap Profile.
Fixing combination with plug for mineral-based foundation/substrate. H-Profile as butt joint connector for UdiBASE® Plinth-End Cap Profile. Distance pieces for levelling compensation.
Recommended for timber-framed and solid timber constructions. Ideally suited for use in affixing the first insulation layer in double layer installations.
Made from 0.8 mm thick stainless steel with a special claw fixing for the efficient extension of the rear lip of the Plinth-End Cap Profile.
The product is used together with either UdiFOUNDATION COAT ® or UdiMULTIGRUND® Base Coat and is bedded into the upper third of the coating nearest the surface. Absorbs dynamic stresses and provides rigidity.
For the subsequent milling of the holes for the heads of the fixings in UdiRECO® Insulation boards. Diameter: 60 mm.
For finishing the edge of the plinth. Affixed using the UdiBASE® Assembly-Set.
This element enables corners to be constructed without any problems.
For a perfect edge finish on the UdiBASE® Plinth-End Cap Profile. It is clipped on to the Plinth-End Cap Profile before the installation of the insulation boards.
Solvent-free special cream to combat rising damp
A self-adhesive PUR-foam tape, pre-compressed (left), self-expanded (right). Wind-tightness is guaranteed. May also be rendered or painted over.
To affix lightweight attachments/fittings directly through the plastered surface. Pre-drill, screw in and then use normal screws.
For use as a protective covering when painting and plastering, 2 m wide